Need some serious help, after trying to retrofit cruise control into the fuse box for a fused 12v at fuse # 12 (non-cruise control loom) I still had the battery connected (idiot!
) and must have either shorted something out or pulled something loose as I was pulling and poking around in the fuse box.
Checked all fuses – Ok
Battery – OK,
Don’t see any disconnected plugs (only pulled on the fuse box enough to tilt a few inches to get at the underside)
No power to anything, which suggests more of a system wide relay/fuse vs. something getting pulled loose.
Question: Is there a master relay or fuse somewhere else that would protect the system if one were to make such a rookie mistake (no sparks or smells, just dead)? Where's the best place to start testing????
) and must have either shorted something out or pulled something loose as I was pulling and poking around in the fuse box.Checked all fuses – Ok
Battery – OK,
Don’t see any disconnected plugs (only pulled on the fuse box enough to tilt a few inches to get at the underside)
No power to anything, which suggests more of a system wide relay/fuse vs. something getting pulled loose.
Question: Is there a master relay or fuse somewhere else that would protect the system if one were to make such a rookie mistake (no sparks or smells, just dead)? Where's the best place to start testing????
Comment